Epson
TM-m10 User’s Manual

Epson

TM-m10 User’s Manual

Before Using the Printer

Important Safety InformationProduct Information PageChecking Items Included with the Printer

Part Names

Part Names

Setup

Checking/Changing the Installation DirectionConnecting CablesConnecting Smart DevicesAttaching the Power Switch Cover

Basic Operations

Turning the Power On/OffRemoving/Attaching the Covers (Rear and Bottom)Feeding the Roll PaperInstalling or Replacing the Roll Paper

Cleaning

Cleaning the Printer CaseCleaning the Thermal Head and the Platen Roller

Troubleshooting

Cannot PrintLED Panel Lights are On/Flashing/OffWhen the Roll Paper JamsThe Roll Paper Cover Does not Open

Appendix

SpecificationsRestriction of UseCAUTIONSTrademarks

Top > Setup > Checking/Changing the Installation Direction

Checking/Changing the Installation Direction

Paper eject position are selectable from top and front.

Place the printer on a flat surface.

Top eject position

Front eject position

CAUTION:
  • Take measures to prevent the printer from moving due to vibrations when using the cash drawer.

  • Do not place the printer in locations subject to high dust levels.

  • Do not give a high impact on the printer during operation. Doing so may cause the print failure.

  • Be careful not to place cords or foreign substances under the printer.

Changing to the front eject position

You can change the eject position by replacing the rear cover and the bottom cover. At the time of purchase, paper is ejected from the top position. When changing to the front eject position, follow the steps below to replace the covers.

  1. Remove the bottom cover and the rear cover. See For the top eject position for more details on the removal procedure.

  2. Attach the rear cover and the bottom cover. See For the front eject position for more details on the installation procedure.

Before Using the Printer

Important Safety InformationProduct Information PageChecking Items Included with the Printer

Part Names

Part Names

Setup

Checking/Changing the Installation DirectionConnecting CablesConnecting Smart DevicesAttaching the Power Switch Cover

Basic Operations

Turning the Power On/OffRemoving/Attaching the Covers (Rear and Bottom)Feeding the Roll PaperInstalling or Replacing the Roll Paper

Cleaning

Cleaning the Printer CaseCleaning the Thermal Head and the Platen Roller

Troubleshooting

Cannot PrintLED Panel Lights are On/Flashing/OffWhen the Roll Paper JamsThe Roll Paper Cover Does not Open

Appendix

SpecificationsRestriction of UseCAUTIONSTrademarks

Top > Setup > Checking/Changing the Installation Direction

Checking/Changing the Installation Direction

Paper eject position are selectable from top and front.

Place the printer on a flat surface.

Top eject position

Front eject position

CAUTION:
  • Take measures to prevent the printer from moving due to vibrations when using the cash drawer.

  • Do not place the printer in locations subject to high dust levels.

  • Do not give a high impact on the printer during operation. Doing so may cause the print failure.

  • Be careful not to place cords or foreign substances under the printer.

Changing to the front eject position

You can change the eject position by replacing the rear cover and the bottom cover. At the time of purchase, paper is ejected from the top position. When changing to the front eject position, follow the steps below to replace the covers.

  1. Remove the bottom cover and the rear cover. See For the top eject position for more details on the removal procedure.

  2. Attach the rear cover and the bottom cover. See For the front eject position for more details on the installation procedure.

©Seiko Epson Corporation 2015-2019. All rights reserved. (M00092007 EN)