===============================================================================
       Fujitsu Touch Panel Driver for MS-DOS


                                           Copyright(C) 2004 SEIKO EPSON CORP.
===============================================================================

1.About this software
   This software package includes the following two application programs to be
    used with SR-600 series.

   1)Touch Panel Driver
      Touch Panel Driver enables operation of MS-DOS programs by touching the
        Touch Panel on the MS-DOS instead of the mouse operation.

   2)Calibration Tool
      This tool adjusts settings so that the touching position on the Touch
        Panel atches the mouse cursor position on MS-DOS.

   System Requirements:
     EPSON SR-600 which operates under the following operating systems
       - MS-DOS 6.22 (English)

2.How to execute the driver
   Executing MEDSTD.COM.

     Ex.
       MEDSTD.COM I10 P2E8 B96 F3E8 D2 [S]

       The meanings of these parameters are as follows.
         - IRQ               = 10
         - I/O Address       = 2E8
         - Baud rate         = 9600
         - Frequency of Beep = 3E8
         - Time of Beep      = 50ms (2*25ms)
       If you use graphic mode, you need parameter "S".
       If you use text mode, you don't need parameter "S".

3.How to execute the calibration
   Executing CALDSTD.COM.

     Ex.
       CALDSTD.COM I10 P2E8 B96 S

       - After executing CALDSTD, it shows only 9 "+" points but no message.
       - Please touch 9 "+" points (after a touch the cross will change color)
          and press "SPACE" key to finish calibration.
       - No message is displayed!
       - After calibration you can do a drawing test with you finger (press
          "ESC" to cancel).
       - No message is displayed!
       - After the drawing you can press "SPACE" to clear the screen or "ESC"
          to cancel.
       - No message is displayed!

5.Notes
   - If you use MOUSE.COM, execute MOUSE.COM earlier than MEDSTD.COM.
   - Please change the BIOS Setup as following.
       - BIOS FEATURES SETUP -> VGA/SVGA Stretching = Enabled